Toner Density Sensor Removal; Trailing Edge Sensor Removal - Lexmark MS510 Series Service Manual

Toner density sensor removal

1
Remove the left cover. See
2
Remove the main drive gearbox. See
3
Remove the rear door and cover. See
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Disconnect the spring (A) from the printer.
8
Remove the two screws (B), and then remove the sensor.
9
Disconnect the cable from the sensor.

Trailing edge sensor removal

1
Remove the left cover. See
2
Remove the right cover. See
3
Remove the rear door and cover. See
4
Remove the power supply. See
5
Remove the power supply shield. See
"Left cover removal" on page
"Main drive gearbox removal" on page
"Rear door and cover removal" on page
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
B
"Left cover removal" on page
"Right cover removal" on page
"Rear door and cover removal" on page
"Power supply removal" on page
"Power supply shield removal" on page
Repair information
166.
223.
226.
166.
178.
223.
232
4514-630, -635, -636
167.
240.
225.
A
240.
225.