4.4 Mounting the MMD-4300 Series LCD Monitor
The MMD-4300 Series LCD monitor can be mounted on a monitor arm or stand.
CAUTION:
When mounting the monitor, take care to tighten the retention screws or bolts
until fully secure, but do not over tighten. Over tightening the retention screws
or bolts may cause them to become stripped, rendering them useless.
4.4.1 Monitor Arm or Stand Installation
The MMD-4300 Series medical LCD monitor has Video Electronics Standards Association
(VESA) standard mounting holes tapped into the rear panel. The standard holes are M4
set at 100mm x 100mm or 100mm x 200mm apart (Figure 4-10).
Figure 4-10: VESA Mounting Holes
To mount the MMD-4300 Series medical LCD monitor onto a monitor arm or stand, please
follow the steps below.
Page 24
MMD-4300 Series Medical LCD Monitor