Table of Contents
Advertisement
Figure 27
Page
-46-
How To Operate the Machine
How to Clean a Floor
WARNING:
Water solutions or cleaning materials
used with this type of machine can
leave wet areas on the floor surface.
These areas can cause a dangerous
condition for the operator or other
persons. Always put CAUTION signs
near the area you are cleaning.
For one touch automatic cleaning follow this procedure:
1.
Turn the key switch to the "OFF" position.
2.
Put the water and a cleaning chemical in the solution
tank.
3.
Sit on the driver seat. NOTE: The machine will not
traverse if the operator is not properly seated.
4.
Turn the key switch "ON". NOTE: The key switch turns
on the battery and LED screen displays, which shows
the machines condition.
5.
The machine has a one touch button on the joystick
(see figure 27) that is preset for brush pressure and
solution flow. Momentarily depress the one touch
button if you wish to use these settings. NOTE: If this is
not the settings that you desire see page 14 or one
touch operation.
For manual control of cleaning process, follow these
procedures:
1.
Turn the key switch to the "OFF" position.
2.
Put the water and a cleaning chemical in the solution
tank.
3.
Sit on the driver seat. NOTE: The machine will not
traverse if the operator is not properly seated.
4.
Turn the key switch "ON". NOTE: The key switch turns
on the battery and LED screen displays, which shows
the machines condition.
5.
Lower the squeegee. NOTE: The vacuum motor will
turn on when the squeegee up/down switch is placed
in the lower position.
6.
Lower the brush head until it reaches the full stroke
down. NOTE: The brushes will start rotating only
when the machine begins to traverse.
7.
Reset the solution flow valve by using the + / - solution
switch. NOTE: The solution will flow only if the
machine is moving forward.
8.
Press the joystick in the desired direction/position.
After the joystick is pressed the machine will begin to
move and the brushes will start to rotate and solution
will begin to flow.
9.
After a few feet of scrubbing, check to see that the
amount of solution being applied is correct and that the
squeegee is picking up water and drying the floor.
Make adjustments as required.
10. Once the machine is set properly continue to scrub until
the solution low indicator comes on or until you run out
of solution.
WARNING:
If the machine develops operating
problems while working, remove your
hand from the joystick. After
resolving the problem, continue
working.
NOTE: When making multiple passes across the floor,
overlap the brush cleaning path approximately 2 inches (5
cm) of the area already cleaned by the brush.
NOTE: During most cleaning procedures, apply and remove
the solution in one operation.
®
Clarke
Operator's Manual -Focus Rider Scrubber
EN
Advertisement
Table of Contents
