Table of Contents
Advertisement
HOW TO OPERATE THE MACHINE (cont.)
HOW TO CLEAN A FLOOR
WARNING: Water solutions or cleaning mate-
rials used with this type of machine
can leave wet areas on the floor
surfaces. These areas can cause a
dangerous condition for the opera-
tor or other persons. Always put
CAUTION signs near the area you
are cleaning.
To clean a floor, follow this procedure:
1. Put the water and a cleaning chemical in the clean
solution tank.
2. Turn the key switch "ON".
3. Lower the squeegee.
4. Put the brush switch in the "DOWN" position.
5. Turn the solution knob to the right to activate the flow
of solution. Adjust the flow of clean solution to the
flow desired.
6. Move the machine across the floor in the forward
direction. See figure #21 (1).
7. When the machine is one machine length from the
end of the area to be cleaned (figure #21 (2)), rotate
the solution knob to the left.
8.
Make a 180
0
turn. See figure #21 (3).
NOTE: When you make more passes across the floor, let
the brushes clean approximately 2 inches of the
area already cleaned by the brushes. See figure
#21 (4).
NOTE: During most cleaning procedures, apply and
remove the solution in one operation.
HOW TO CLEAN A VERY DIRTY FLOOR
To clean a very dirty floor, follow this procedure:
1. Apply solution to the floor.
2. Do not lower the squeegee.
3. Do not activate the vacuum motor.
4. Lower the brushes and scrub the floor.
5. Leave the solution on the floor long enough for the
solution to begin cleaning the floor.
6. Scrub the floor again with additional solution, picking
up all the solution with the squeegee
Page
-20-
CLARKE TECHNOLOGY Operator's Manual -Encore S28/L28/S33/L33/S38/L38
3
4
2
Figure #21
Advertisement
Table of Contents
