Do These Procedures When You Begin Your Work Period - Clarke Focus Operator's Manual

Figure 24
Figure 25
Figure 26
Page -44-
How To Operate the Machine (cont.)
To traverse the machine follow this procedure:
1. Sit on the driver seat.
traverse if the operator is not properly seated.
2. Turn the key switch to the "ON" position.
3. Raise the brush to the highest position.
4. Raise the squeegee.
6. Gently press on the joystick in the direction you
want to travel. The machine will begin to move.
7. To change the speed of the machine move the
joystick. Move it in the direction you want to travel.
8. To stop, release pressure on the joystick and allow
it to re-center.
9. To travel in reverse, move the joystick in the reverse
position. NOTE: Keep the joystick pointed in
the direction you wish to go.
10. To stop, release the joystick.
11. To turn the machine, move the joystick in the
direction you want to turn.
14. When you stop the machine, turn the key switch
"OFF" and remove the key.
Do These Procedures When You Begin Your Work
Period
1. Make sure the key switch is in the "OFF" position.
2. Disconnect AC power from battery charger (follow
charger instructions).
3. Make sure the filter screen (1) to the vacuum motor
is clean and installed properly in the recovery tank
(see figure 24).
4. Make sure the recovery tank lid is in place and has
been tightened (see figure 25, A).
5. Close and secure the lower cleaning port cover on
the recovery tank (see figure 25, B).
6. Make sure that the plug in the recovery drain hose
is in place and has been tightened (see figure 26).
7. Make sure that the brushes/pads are in position
and installed correctly.
8. Make sure the brush housings are in position on
the brush head.
9. Check the installation of the squeegee and
squeegee hose.
®
Clarke
Operator's Manual -Focus Rider Scrubber
EN
NOTE: The machine will not