Vitotronic 100, GC1B Installation and Service
Overview of System Examples
Boiler
Single Boiler Systems
1
Vitorond (VD2A)
2
Vitorond (VD2)
3
Vitocrossal (CT3)
Multi Boiler Systems
4
Vitorond (VD2A)
5
Vitorond (VD2)
6
Vitorond (VD2)
7
Vitorond (VD2A)
8
Vitocrossal (CT3),
Vitorond (VD2/VD2A)
9
Vitocrossal (CT3),
Vitorond (VD2/VD2A)
Characteristics
Therm-Control
Shunt pump and 3-way mixing valve for raising the return temperature
Several heating circuits and one low temperature heating circuit
Therm-Control
Shunt pump for every boiler for return temperature raising
3-way mixing valve for raising the return temperature
Several heating circuits and one low temperature heating circuit,
Therm-Control
Several heating circuits and one low temperature heating circuit and low
temperature boiler with shunt pump
Several heating circuits and one low temperature heating circuit and low
temperature boiler with 3-way mixing valve and boiler circuit pump
These system examples are merely recommendations
and must therefore be checked on site for completeness
and function.
The heating circuits must be regulated by an external
control unit.
Connect three-phase consumers via additional
contactors.
For multi boiler systems, the cascade and DHW tank
temperature must be controlled by a higher third party
control unit.
For multi boiler systems, all the relevant coding
addresses must be set on each Vitotronic 100.
For connecting a single boiler system to a higher third
party control unit, see page 62.
For connecting a multi boiler system to a higher third
party control unit, see page 66.
Installation Examples
Page
10
14
18
22
26
30
34
38
42
7