HYOSUNG Aquila 250 Service Manual page 164

� REAR SPROCKET MOUNTING DRUM BEARING
● Remove the bearing by using specical tool.
Bearing remover(17mm) : 09923 - 73210
CAUTION
The removed bearing should be replaced with
new one.
◉ REASSEMBLY
Reassemble the rear wheel and rear brake in the
reverse order of disassembly.
Pay attention to the following points :
� WHEEL BEARING
● Apply SUPER GREASE "A"to the bearing before
installation.
SUPER GREASE " A "
● Press fit the bearing to the wheel using the special
tools.
Steering race installer : 09941 - 34513
CAUTION
First install the right wheel bearing, then left
wheel bearing.
� REAR SPROCKET MOUNTING DRUM BEARING
● Install the rear sprocket mounting drum bearing and
dust seal using the special tool.
Steering race installer : 09941 - 34513
NOTE:
Apply grease to the bearing and dust seal lip before
assembling the rear sprocket mounting drum.
SUPER GREASE " A "
GREASE
CHASSIS 6-36