Alpine INE-NAV-30 Owner's Manual page 214

• For INE-S920HD/INE-NAV-30
Mounting Sleeve
(Included)
Pressure
Plates*
1
Dashboard
Face Plate*
2
(Included)
*
1 If the installed mounting sleeve is loose in the
dashboard, the pressure plates may be bent slightly to
remedy the problem.
*2 The supplied face plate may be mounted.
s
Reinforce the head unit with the metal
mounting strap (not supplied). Secure the
ground lead of the unit to a clean metal
spot using a screw(* 1) already attached to
the vehicle's chassis.
Connect all the leads of the INE-S920HD/
INE-NAV-30 according to details described
in the CONNECTION section.
HexNut(MS)
Metal
Mounting
Strap
Ground Lead
Screw
Chassis
This unit
• For the screw marked "* 2," use an appropriate screw for
the chosen mounting location.
6
Slide the INE-S920HD/INE-NAV-30 into the
dashboard until it clicks. This ensures that
the unit is properly locked and will not
accidentally come out from the dashboard.
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
ACC
INE-S920HD/INE-NAV-30 (Red)
I~
INE-Z928HD/INE-NAV-38 BATTERY
(Yellow)
.------------,
( SPST SW (Optional) : (Optional)
0
- -
~
. . . .
~·
-----o·'o----. . . .
1
-F-IU=SEJ-(""""SA)
..:="!..-- ___
!1._-_______________________
-c::~
....__.
FUSE (20A)
(Optional)
• If
your vehicle has no ACC power supply, add an SPST (Single-Pole, Single- Throw) switch (sold separately) and fuse (sold
separately).
• The diagram and the fuse amperage shown above are in the case when INE-S920HD/INE-NAV-30/INE-Z928HDIINE-
NAV-38 is used individually.
• If
the switched power (ignition) lead of the INE-S920HD/INE-NAV-30/INE-Z928HD/INE-NAV-38 is connected directly
to the positive (+)post of the vehicle's battery, the INE-S920HD/INE-NAV-30/INE-Z928HDIINE-NAV-38 draws some
current (several hundred milliamperes) even when its switch is placed in the OFF position, and the battery may be
discharged.
13-EN