Apply The Decals; Get The Model Ready To Fly; Check The Control Directions - GREAT PLANES Revolver 50W Instruction Manual

❏
13. Slide the wings onto the tube, making sure to feed the
servo lead from the wing through the hole in the side of the
fuselage. Slide the wing snug to the fuselage sides.
❏
14. Locate the two nylon wing bolts. Secure the wing to the
fuselage by tightening the bolts to the fuselage.
❏
15. Install the canopy onto the top of the fuselage, aligning
the pins in the front of the canopy with the holes behind the
cowl. Secure the canopy with four 4-40 x1" [25mm] screws,
#4 fl at washers and #4 lock washers.

Apply the Decals

Use the photos on the box to determine where to place your
decals.
❏
1. Remove the decals from the sheet.
❏
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water—about one teaspoon of
soap per gallon of water. Submerse the decal in the soap and
water and peel off the paper backing. Note: Even though the
decals have a "sticky-back" and are not the water transfer type,
submersing them in soap & water allows accurate positioning
and reduces air bubbles underneath.
❏
3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
❏
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.

GET THE MODEL READY TO FLY

Check the Control Directions

❏
1. Turn on the transmitter and receiver and center the trims.
If necessary, remove the servo arms from the servos and
reposition them so they are centered. Reinstall the screws
that hold on the servo arms.
❏
2. With the transmitter and receiver still on, check all the
control surfaces to see if they are centered. If necessary, adjust
the clevises on the pushrods to center the control surfaces.
24