Install The Radio System - GREAT PLANES Revolver 50W Instruction Manual

❏
22. Screw a 2-56 x 1" [25mm] threaded wire ¼" [6mm] into
the remaining inner pushrod. Screw the nylon ball link you cut
onto the threaded wire. Slide the pushrod tube into the tube
you installed in the fi rewall and snap the ball link onto the ball
you installed on the choke arm.
❏
23. Position the choke fully open and rotate the choke servo
arm to the position to open the choke. Locate another 2-56
x 1" [25mm] threaded wire, 2-56 nut, 2-56 threaded clevis
and silicone clevis retainer. Thread the assembly together.
Place the clevis in the outer hole of the servo arm. Cut the
inner pushrod to the fi nal length required for the threaded
wire to screw into the pushrod. Install the wire, clevis, 2-56 x
1" [25mm] threaded wire, 2-56 nut, 2-56 threaded clevis and
silicone clevis retainer into the pushrod tube. Install the clevis
into the outer hole of a short, 5/8" [16mm] servo arm.
❏
24. Locate the four 16" [406mm] nylon tie wraps. Insert one
into each of the slots in the plywood plate as shown. After you
have inserted one into each slot, attach a second tie wrap to
both of the fi rst tie wraps.
❏
25. Install fuel lines onto each of the lines coming out of
the fuel tank. Once the lines have been installed feed the lines
through opening in the front of the fuselage. The carburetor
line should be inserted through the hole you drilled for it in
the fi rewall. The vent and fi ll line can be inserted through the
openings in the bottom of the fi rewall box. Place the tank
between the tie wraps. Secure the tank by tightening the tie
wraps against the tank. Trim off the excess tie wrap strap.
❏
26. Trim the carburetor fuel line to the proper length and
install it onto the fuel inlet.

Install the Radio System

❏
1. Install your receiver with a piece of R/C foam under it
and secure it in place with the included Velcro strap.
19