Install The Rudder Servo & Pull-Pull Wires - GREAT PLANES Revolver 50W Instruction Manual

on the wires. Secure the tail wheel with the wheel collars and
3mm x 5mm [3/16"] screws. Be sure that you apply thread
locker when installing the screws.
❏
11. Install the tail wheel assembly to the fuselage with two
#4 x 5/8" [16mm] screws, #4 lock washers and #4 fl at washers.
❏
12. Locate the two tail wheel wire springs. With the rudder
centered with the vertical fi n, attach the springs to each side
❏
10. Re-assemble the
tail wheel as shown. Be
sure that you apply a drop
of thread locker onto the
screws. The tail wheel
should be positioned on
the wire between two 3mm
wheel collars secured
by 3mm x 5mm [3/16"]
screws. Before fi nalizing
the tail wheel installation
make a mark on the wires
where the screws contact
the wire. Make a fl at spot
of the tail wheel assembly, inserting and twisting the wires
into the control horn and steering arm in the holes shown.
Install the Rudder Servo
& Pull-Pull Wires
❏
1. From the servo horns that are included with your servo
locate the four arm horn. Remove two of the four arms, center
the servo and then install the servo arm onto the servo as
shown.
❏
2. Using the hardware that came with your servo, install
the servo in the opening in the fuselage as shown.
❏
3. Locate the braided cable, four brass tubes (called a
swage) and four threaded brass 4-40 couplers. Use wire
cutters to cut the supplied braided cable into two equal lengths.
13