GREAT PLANES Revolver 50W Instruction Manual page 16

❏
6. Locate three brass tubes and fi ve fuel barbs. Solder the
barbs to one end of each of the three tubes.
❏
7. Insert each of the three tubes through the metal plates
and the rubber stopper. Note: One of the holes in the stopper
is not open and will have to be cut open before the tube can
be inserted. Slide the metal plate with the threaded hole over
the brass tubes.
❏
8. Solder a fuel barb on the carburetor fuel tube and the
vent line (this is the two shortest tubes)
❏
9. Install fuel lines onto the fuel tubes (not included) and
then install the fuel clunks on the fuel line. When determining
the length of the fuel line, be sure the clunks are able to move
freely in the fuel tank. Bend the vent line upward towards the
top of the fuel tank.
❏
10. Slide the aluminum ring over the fuel lines before
installing the stopper into the fuel tank. Install the stopper into
the tank. Slide the aluminum ring onto the neck of the tank.
Make sure when you insert the stopper that the vent line is
at the top of the tank. Secure the stopper by installing the
stopper screw through the center of the metal plate, tightening
the stopper to the tank. Set the fuel tank aside.
❏
11. On both sides of the fuselage is a location to mount the
throttle servo. The side of your engine that the carburetor is
located on will determine which side of the fuselage your servo
is mounted. For the DLE engine, mount the servo on the left
side of the fuselage. If your engine is on the right side of the
engine mount, the servo is on the right side of the fuselage.
Use the hardware included with the servo to mount it.
16