GREAT PLANES Revolver 50W Instruction Manual page 18

choke servo you should know that the location of the servo
will make it a little more diffi cult to tighten the wing attachment
bolt. If you will be using a manual choke skip ahead to step 24.
❏
17. Place the tray on the same side of the fuselage as the
throttle servo, against the wing tube and the slot in the battery
tray. Drill a 1/16" [1.6mm] hole through the tray. Secure the
choke servo tray with four #2 x 3/8" [10mm.] screws and #2
washers.
❏
18. Install the choke servo into the tray using the hardware
that came with the servo. Install a short 5/8" [16mm] servo
arm on the servo.
❏
16. Locate the
plywood choke servo
tray parts and the
❏
two hardwood blocks.
hole in the fi rewall in line with the choke, into the fuselage
Glue the tray together
and through the hole in the support former and resting in the
as shown.
notch in the former ahead of the wing tube. Mark the tube
where the tube contacts the fi rewall and formers. Remove the
tube and then roughen the tube with sandpaper in the areas
that contact the fi rewall and the formers. Reinstall the tube
and glue it to the fi rewall and formers.
❏
to the pushrod tube, securing it to the former.
❏
the end of the ball link.
18
19. Install the remaining outer pushrod tube through the
20. Locate the 3mm plywood half ring plate. Glue it in place
21. Locate the remaining nylon ball link. Cut ¼" [6mm] from