Starting The Machine; Burnishing; Post Operation Checklist - Pioneer Eclipse revolution REV24NXG Operator's Manual

Starting the Machine

1. Complete your pre-operation check.
2. Turn propane cylinder service valve
counter-clockwise to open.
Note: Always open the service valve slowly to allow
pressure to equalize in the hoses. Opening the service
valve too quickly may cause the flow check valve to
engage, limiting the fuel flow.
3. With the engine bail throttle pulled back, engage
the starter by turning the key switch to the starting
position for approximately 5 seconds. If the
engine does not start, release the key switch for
10 seconds, then try to start again for another 5
seconds.
4. After the engine has started, allow the engine to
warm up for approximately 30 seconds. For
optimum performance, only burnish at the full
throttle position.
Note: The Revolution comes with an onboard ECU that
continually monitors and controls the engine's fuel injection
system. In addition, the machine is equipped with a
catalytic muffler. The Service Engine light will NOT be
illuminated as long as the machine is safely and properly
operating. Refer to the "Machine Troubleshooting" section,
if the Service Engine light flashes.
WARNING! Catalytic mufflers require a few minutes to
warm up before effectively removing harmful emissions.
Make sure of proper ventilation during this warm-up
period!
13

Burnishing

1. Dust mop and scrub the floor to clean it.
2. After the engine has been started and properly
warmed, pull back on the bail throttle to increase
engine speed and engage the clutch.
3. Lower the burnishing head to the floor while
moving the machine forward.
Note: The burnisher should always be operated at full
throttle engagement to ensure adequate air movement
through the cooling radiator.
4. Try to burnish in open areas with minimal
obstructions. Use a smaller burnisher for more
confined areas.
CAUTION! Keep the burnisher moving when the
burnishing head is rotating. Failure to do this may result in
finish damage.
CAUTION! DO NOT add weight to the burnisher head.
CAUTION! DO NOT lift up on the handle to add pressure
while burnishing.
Note: To not comply with any of the CAUTION!
statements could cause the engine to overheat and/or
damage the padholder, drive components or dust skirt.
5. When done burnishing, push the machine to the
desired location. Turn off the LP cylinder service
valve. When the fuel is depleted and the engine
stops, turn the key switch OFF.
6. Remove the LP cylinder and store properly. Refer
to Refueling and Storage of Fuel Cylinders.

Post Operation Checklist

Turn off the LP cylinder service valve. When the fuel
is depleted and the engine stops, turn the key switch
OFF.
Check the dust container and dust filter. Empty the
container and clean the filter, if necessary. Refer to
Maintenance.
Check under the machine for leaks and loose
fasteners.