Mounting - Electrical Installation; Description Of Printed Circuit Board Connectors - 2N Helios IP Vario Installation Manual

2.3 Mounting – Electrical Installation
®
2N
(10/100BASE-T) using a UTP cable. Use a CAT 5e UTP cable at least for connection.
®
2N
additional cabling is therefore necessary. If your Ethernet is not equipped with the PoE
technology, it is possible to use a PoE injector, Part No. 91378100. As an alternative,
you can use a power adapter, Part No. 91341481E. 2N
over an integrated administration web server, which can be controlled from any web
browser, e.g., Mozilla Firefox.

Description of Printed Circuit Board Connectors

In Figure 2.11 you can see the location of the printed circuit board (PCB) connectors.
Connectors to which the accessories can be connected and connectors that serve for
configuring 2N
Ethernet connection is to be connected to the terminal block X2 as shown in Table
2.1. The terminal block can be removed from the PCB. The connection of each of the
connectors is described in the subsections below.
Helios IP Vario is designed for connection in the Ethernet computer network
Helios IP Vario is fed through the PoE (Power over Ethernet) technology. No
®
Helios IP Vario are indicated on the board. The UTP cable for the
Mounting – Electrical Installation
®
Helios IP Vario is configured
2.3
23