Comtech EF Data MBT-4000B Installation And Operation Manual page 45

Multi-Band Transceiver System
Remote Command
Valid
Command
on
Parameter (Instruction
MBT,
Type Code and
BDC,
qualifier)
or
BUC
Automatic AFR=x All
Fault
Recovery
State
Attenuation ATT=xx.xx BDC
BUC
Clear All CAA= All
Stored
Alarms
Arguments
for
Command (Note that all arguments are ASCII numeric codes, that is, ASCII codes
or Response
to Query
1 byte, value Command or Query.
of 0, 1 Enable Automatic Fault Recovery on a BXC as follows:
0=Disabled
1=Enabled
Example: AFR=1
5 bytes, Command or Query
numeric Valid attenuation level, in dB, at 0.25dB step size as factory default.
Example: ATT=08.25
None Command only.
Instructs the slave to clear all Stored Events.
This command takes no arguments.
9
MN/MBT4000B.IOM
Description of arguments
between 48 and 57)
Revision 0
Response to Query
Command (Instruction
(target to Code and
controller) qualifier)
AFR=(message AFR?
ok)
AFR? (received ok,
but invalid
arguments found)
AFR*(message ok,
but not permitted in
current mode)
ATT=(message ok)
ATT? (received ok,
but invalid
arguments found)
ATT*(message ok,
but not permitted in
current mode)
ATT! (Command
not accepted by
MBT-4000B base
unit. It must be
addressed to BUC
or BDC sub-units)
CAA=(message N/A
ok)
Response to
query
(target to
controller)
AFR=x
(same format
as command
arguments)
N/A