INSTALLATION
The following paragraphs define the installation instruc-
tions for the terminal.
All procedures
~eferenced
in the
instructions are contained in section 6 of this manual.
An
index is provided at the end of section 6 that lists the
page numbers for the various procedures.
1) Set terminal on flat surface in area in which it is
to be used.
The terminal uses natural convection
for its ventilation: allow a 4-in (101.6 mm) clear-
ance around the terminal.
2) Set terminal power ON/OFF switch to OFF (proce-
dure 1).
3) If internal modem is being employed, unplug the
telephone set from the wall jack and plug it into
the terminal jack labeled PHONE.
Using the tele-
phone cable supplied with the terminal, connect the
terminal to the telephone line by plugging one end
of this cable into the terminal jack labeled LINE
and the other end into the wall jack (figure 3-2).
NOTE
If PLATO interface (RS-232 or long
long driver) is to be used (no inter-
nal modem), see steps
4
through
6
for
assembly instructions.
MINIATURE MOOUt.AR PL.UG
CDC PART NUMBER 51917910
TER MI N At. - MOU NTEC
MINIATURE MOCUt.AR JACK
CDC PART NUMBER 51917909
~--------~--~
Figure 3-2.
Terminal/Telephone Connection
82100083 D
3-3
Need help?
Do you have a question about the INFORMATION SYSTEMS TERMINAL II and is the answer not in the manual?