Control Data Corporation INFORMATION SYSTEMS TERMINAL II Hardware Maintenance Manual page 50

NOTE: PERFORM THE FOLLOWING STEPS IN ORDER.
I.
INTERLOCK FOAM BASE LEGS WITH END FRAMES.
2. PLACE END FRAMES WITH BASE LEGS ON DISPLAY STATION.
3. PLACE DISPLAY STATION WITH END FRAME CUSHIONING INTO EXTERIOR CONTAINER.
4. LOCK "I." BLOCKS IN POSITION.
5. SECURE POWER CABLE IN SLITS OF END FRAMES. (DONT LET PLUG DANGLE).
6. CLOSE AND SEAL EXTERIOR CONTAINER WITH 3-in REINFORCED BOX SEALING TAPE.
03457-1
Figure 3-1. Terminal Packaging
3-2 82100083