2.2 IR PTZ camera and network IR PTZ camera installation
2.2.1 PTZ camera bracket installation
The PTZ camera has several different types of installation brackets. You can refer to the following contents for
detailed information. This section will show you how to install the IR PTZ camera into the wall mount bracket.
2.2.2 Pipe thread bracket installation
Please connect the quick installation port to the wall mount bracket (Pipe thread connection) and then use the
M4 stainless steel bolt to fix securely. Then you can connect the integrated cable to the composite cable of the
flanges. Please connect the corresponding power, video output, RS 485 control, network and alarm input &
output cables respectively (Please connect as your actual requirements). Finally, you can connect the flange to
the quick installation port. See Figure 2-1.
Please note the analog PTZ camera does not have the network cable connection. You can connect the RS485,
video output cable if necessary.
VIDIO:
Video OUT
RS485:
Yellow = A +
Orange = B -
POWER:
Red = AC24V
Black = AC24V
Yellow & Green = GND
© Copyright Qvis® All documentation rights reserved.
Figure 2-1
AUDIO:
White = AUDIO IN
Black = GND
Red = AUDIO OUT
ALARM:
Blue = Alarm out
White = Com 1
Red = GND
Black = Alarm in 2
5