Protocol, Baud Rate, Address Setup; Protocol And Baud Rate Setup - Qvis APOIR-PTZ23 User Manual

Before you start operating the camera, you need to set the protocols, baud rate and address. Otherwise
you will not be able to control the product!

8.1 Protocol and Baud Rate Setup

Please configure the following settings before begin controlling dome:

Protocol

Baud rate

Address
Note: Please reboot the PTZ camera to get all the setups activated!
Open the lower dome, the interface is shown as below. See Figure 8-1.
SW2
© Copyright Qvis® All documentation rights reserved.

8 Protocol, Baud Rate, Address Setup

Figure 8-1
SW1
18