Table of Contents
Advertisement
5.1 Component Installation
Hang mount bracket and its components are shown below. See Figure 5-1.
5.2 Installation
5.2.1 Installation Requirements
The hang mount PTZ camera can be installed on to a hard construction wall in either indoor or outdoor
environments. Before the installation, please make sure:
1.
The wall is thick enough to install the expansion bolt.
2.
The wall can at least sustain the 4x weight of the PTZ camera.
5.2.2 Installation Steps
Loosen the M4 bolt on the flange side to separate the flange from the steeve. Pull the integration cable through
the airproof slot of the bottom of the flange and then connect to the centre hole of the flange. Please secure the
flange in the ceiling. See Figure 5-2. Please note, if the PTZ camera is installed in an outdoor environment,
you need to paste the silica gel on the surface of the flange and the surface and the cable exit.
© Copyright Qvis® All documentation rights reserved.
5 Hang Mount Bracket Installation
Figure 5-1
Silica gel
Figure 5-2
Connect
to flange
12
Advertisement
Table of Contents
