Follett Symphony 110 Series Installation & Service Manual page 9

Fig. 1 – Rear connections, freestanding models
(B) 3/4" FPT drain
(A) 3/8" FPT
water inlet (A)
(D) 3/8" FPT
condenser inlet
location (water-
cooled only)
water inlet
(E) 3/8" FPT
condenser drain
location (water-
cooled only)
(C) 3/4" MPT
icemaker drain
location (air-
cooled only)
12. Verify that water sensor tabs are immersed in water in reservoir.
13. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward.
14. If dispenser is equipped with SensorSAFE, remove protective plastic coating from dispense sensor labels.
15. Turn on dispenser power and bin signal rocker switches. Check dispenser and icemaker operation.
16. Sanitize icemaker according to instructions in icemaker manual. Discard sanitized ice.
17. Turn off icemaker bin signal switch.
18. Remove dispenser hopper lid; clean and sanitize dispenser according to instructions beginning on page 14.
19. Turn icemaker bin signal switch on and replace front covers, securing with screws.
access panel
10.25"
(260mm)
9
31.5"
(800mm)
(C) 3/4" MPT
icemaker drain
location (water-
cooled only)
31.5"
(800mm)