ZyXEL Communications U-336S User Manual page 87

Command
+FNS="string"
+FPI="string"
+FPR=n
+FPS=n
+FRQ=pgl,cbl
Value Description
+FCI: and +FPI: response reports are
suppressed.
idr=1 ID Strings are reported. +FNF:, +FNS:
and +FNC: response reports are
generated.
nsr=0 Non-standard frames are not reported.
+FTI: +FCI: and +FPI: response reports
are suppressed.
nsr=1 Non-standard frames are reported.
+FTI:, +FCI: and +FPI: response
reports are generated.
Non-standard byte string parameter.
"string": string of hexadecimal coded
octets.
Local fax station ID string, for polling
Rx.
Serial port rate control parameter:
n=0 Automatic DTE rate detection by the
DCE.
n>0 Serial rate is fixed at the value
multiplied by 2400 bps. For example,
when n=8, the DTE rate is equal to
19200 bps (8x2400).
Page transfer status: refer to the +FPTS
Class 2 command in previous sections
for settings.
Receiving quality threshold parameters:
pgl= Specify the percentage of good lines
0-64 (e.g. with negotiated number of pixels)
(HEX required for a page considered
value) acceptable. The percentage of good
lines would be computed by the
Fax Operation 75