ZyXEL Communications U-336S User Manual page 85

Command
+FCR=n
+FCT=n
+FDR
+FDT
+FEA=n
+FIE=n
+FIP
+FIS=vr,br,wd,l
n,df,ec,bf,st
Value Description
"Capability to receive" parameter
n=0 DCE will not receive message or poll a
remote device.
n=1 DCE receives message data or polls a
remote device
0-255 DTE phase C time-out parameter. n=0-
255, 1s units.
Receive phase C data command initiates
document reception
Transmit phase C data command:
releases the DCE to proceed with
negotiation
Phase C received EOL alignment
parameter
n=0 Determine that T.4 EOL patterns are bit
aligned (as received).
n=1 Determine that the last received bits of
T.4 EOL patterns are byte aligned by
the DCE, with necessary zero fill bits
inserted.
Procedure interrupt parameter
n=0 Procedure interrupt requests from the
remote station are ignored, and not
reported to the DTE.
n=1 Procedure interrupt requests from the
remote station are accepted, negotiated
and reported using the +FVO response.
Initialize facsimile parameters to factory
default.
Current session parameter. refer to
+FDCC Class 2 command in previous
section parameter settings.
Fax Operation 73