Recording; Playback Preparations And Operations; Making Settings Related To Audio Monitor Signals; Adjusting Playback Audio Levels - Sony SR-R1 Operation Manual

To record the user bits
By setting user bits, you can record up to eight
hexadecimal digits of information (date, time,
etc.).
To set an arbitrary value and then record user
bits
1
Set the TC Setup menu.
To set arbitrary user bits regardless of the
setting of "TCG MODE," set TCG SET >
UBG SOURCE to "INT." If "TCG MODE"
is set to "PRST," TCG SET(MAIN) > UBG
SOURCE can be set to any value.
For details, see "To select the time code to
record" (page 33).
2
Set the user bits using the same
procedure as "To set the initial value and
record the time code" (page 34).
Tip
As with the time code, all digits can be returned to 0 with
"TIMER RESET."

Recording

1
Check that the REC INHI indicator is
off and then insert an SRMemory card.
Before you insert the SRMemory card, check
that its write-protect switch is not set to
"WP."
For details, see "To insert the SRMemory card"
(page 24) and "Write-protecting the card"
(page 25).
When the REC INHI indicator is lit
Record inhibit is set.
• Set SYSTEM Setup > REC INHI to "OFF."
(see page 74)
• Check that FS LOCK for the SRMemory
card is not locked. (see page 76)
• Check that the write-protect switch for the
SRMemory card is not in the WP position.
2
Press the PLAY button while holding
down the REC button.
Recording starts, and "REC LOCK" appears.
3
Press the STOP button to stop
recording.
Playback Preparations
and Operations
Making Settings Related to Audio
Monitor Signals
The AUDIO Setup menu allows you to make
various settings related to audio monitor signals
for playback. The setting procedures are the same
as for recording.
For details, see "Setting the Audio Signals"
(page 30) and "AUDIO Setup Menu" (page 67).
To adjust the level of audio output via the
EARPHONES jack
Rotate the LEVEL knob.

Adjusting Playback Audio Levels

The playback audio level can be set for each
channel in "PB LEVEL" of the AUDIO Setup
menu.
The setting procedure is the same as in steps 2 and
3 of "To set the recording levels" (page 32).
Note
The playback audio level cannot be adjusted during
recording.
To set the display range of the audio level meters
See "To set the display range of the audio level
meters" (page 31) for during recording.
Selecting the Time Data to
Display During Playback
Display the TC Setup menu and then select the
time data you want to display in "TIMER SEL."
TC: Displays the LTC or VITC.
Select which one is displayed in "TCR SEL" in
the TC Setup menu.
UBIT: Displays the user bits for the time code
selected in "TCR SEL" in the TC Setup menu.
TM1/TM2: The values counted in accordance with
the playback frames.
(With TM2, the beginning of the file is 0 and the
value cannot be reset.)

Playback Preparations and Operations

35