Auto On And Off: Setting The Time; Light Ring; Catalytic Recondition - TurboChef ngo Service Manual

Auto On and Off: Setting the Time

From screen 2 of the Info Mode (Figure 13, page
11), press the L4 soft key to access the Set Date/
Time screen (Figure 16). The real time, "auto-on"
time, and "auto-off" time can be set.
An accurate real time is critical for the usability of
auto-on and auto-off. When these features are enabled
from the 1st Options Screen (Figure 14, page 12),
the oven will automatically turn on or off at the time
specified.
An accurate date and time also helps ensure the
accuracy of diagnostics and fault reporting. The
oven time and date are set at the time of
installation; however, an adjustment may be
required at some point.
NOTE: The clock will not automatically update for
Daylight Savings Time.
NOTE: The clock is 24-hour (8:30 p.m. = 20:30).
NOTE: The oven will not retain the date and time
if it is left unplugged for two or more weeks.
IMPORTANT: For auto-on and auto-off to be
active, they must be enabled from the 1st Options
Screen (Figure 14, page 12).
To set the real-time date and time,
1. Use the L2 and R2 soft keys (middle left and
middle right) to navigate between digits.
2. Use the number keys to enter the month, day,
and year, followed by the hour and minute.
3. Select "Save" to save your changes or press the
Back/Stop key to cancel.
L1
S AVE
SE T DATE/TIME
M M/DD/Y Y HH: MM
L2
< 0 1 /01 /00
AU TO ON
HH: MM
L3
<
AUTO OF F
HH:MM
L4
<
Figure 16: Set Date/Time
R1
TEMP 1
R2
14:45 >
TI ME
R3
05: 30 >
TIME
R4
16:00 >
To set the auto-on or auto-off time,
1. Ensure the real-time clock is accurate.
2. Press the R1 soft key to toggle between
temperatures 1 and 2. If two different temper-
atures are used for cooking, they must be set to
different auto-on and auto-off times.
3. To navigate between digits, use the L3 and R3
soft keys for auto-on time and the L4 and R4
soft keys for auto-off time.
4. Use the number keys to enter the desired hour and
minute for the oven to automatically turn on or off.
5. Select "Save" to save your changes or press the
Back/Stop key to cancel.

Light Ring

From the 2nd Options Screen (Figure 15, page 12),
press the R1 soft key to turn the light ring on or off.

Catalytic Recondition

From the 2nd Options Screen (Figure 15, page 12),
press the R1 soft key to turn "cat_recon" on or off.
This feature is available on select oven models only,
in order to help burn off excessive grease in the
catalytic converter or surrounding airpath.
When enabled, a catalytic recondition cycle will be
performed each time the oven is warmed up from
cold. When the ON/OFF key is pressed, the oven
will begin to climb to the catalytic recondition set-
point (540ºF) for a 20-minute cycle.
CAUTION: During reconditioning, do not
open the oven door, as the sudden addition
of oxygen to the oven environment may cause
any remaining food particles to ignite.
13