Viewing The Service Numbers; Options Screen; Setting The Language; Setting The Date/Time - TurboChef i3 Service Manual

14 INFO MODE

Viewing the Service Numbers

From the Info Mode (Figure 15, page 13), press the
R4 soft key to view technical support contact info.

Options Screen

From screen 2 of the
press the L2 soft key to access the Options screen
(Figure 19). When prompted, enter the password
9 4 2 8 and press the Enter key.
From the Options screen, the following oven options
can be turned on or off:
- Adjust Time screen (see cooking step 6, page 11
for more details)
- Cook More screen (see cooking step 9, page 12
for more details)
- Edit Mode (page 19 for more details)
- Load Menu screen (page 15 for more details)
- Demo Mode (TurboChef use only)
- DHCP (TurboChef use only)
- Oven Type: Ensure this option is set to "i3."

Setting the Language

NOTE: Not available on some oven models.
From screen 2 of the
press the L3 soft key to set a different language.

Setting the Date/Time

Having an accurate date and time is important for
logging oven counts, diagnostics, and fault conditions,
should any occur. The oven time and date are set at
the time of manufacture; however, the technician may
at some point be required to make an adjustment.
L1
ADJ TIME
L2
COOK MORE
L3
EDIT MODE
L4
LOAD MENU
L5 DEMO MODE
Figure 19: Options Screen
(Figure 16, page 13),
INFO MODE
(Figure 16, page 13),
INFO MODE
OVEN OPTIONS
OFF DHCP OFF
ON
ON
ON
OFF OVEN TYPE I3
From screen 2 of the
press the L4 soft key to access the "Set Date/Time"
screen (Figure 20).
To set the date and time,
1. Use the L3 and R3 soft keys (middle left and
middle right) to navigate between fields.
2. Use the numeric keypad to enter the month,
day, and year, followed by the hour and minute.
NOTE: The clock is a 24-hour clock (e.g., 20:30 =
8:30 PM).
3. Select "Save" to save your changes or "Cancel"
to cancel and exit the screen.
NOTE: The oven will not retain the time if it is left
unplugged for two or more weeks.

Adjusting the Volume

From screen 2 of the
press the L5 soft key to adjust the beeper volume.

Setting the F2 Alarm

Under normal operation, the F2 alarm will terminate
a cook cycle if the CC temperature falls below 84°F
(47°C) of the set point. Turning off the F2 alarm will
prevent a cook cycle from being terminated if the
fault is discovered. In either event, the fault will be
logged and should necessitate a service call.
To turn the F2 alarm on or off, press the R2 soft key
from the Info 2 screen (Figure 16, page 13).
R1
L1
R2
L2
R3
L3
<
R4
L4
R5
CANCEL
L5
Figure 20: Set Date/Time
(Figure 16, page 13),
INFO MODE
(Figure 16, page 13),
INFO MODE
SET DATE/TIME
MM / DD / YY HH:MM
_
0 9 / 2 9 / 0 9 2 0 : 3 0 >
SAVE
R1
R2
R3
R4
R5