Initialize Nvm; Ans Select; Auto Answer Fax - Fuji Xerox DocuPrint M215 b User Manual

• Initialize NVM

Purpose:
To initialize wired network data stored in Non-Volatile Memory (NVM). After executing this function and
rebooting the printer, all wired network settings are reset to their default values.
Values:
Yes
No*
Fax Settings (DocuPrint M215 fw Only)
Use the Fax Settings menu to configure the basic fax settings.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.

• Ans Select

Purpose:
To select the default fax receiving mode.
Values:
TEL Mode
FAX Mode*
TEL/FAX Mode
Ans/FAX Mode
DRPD Mode

• Auto Answer Fax

Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call.
The interval can be specified within the range of 0 to 255 seconds. The default is 0 second.
Initializes the wired network data stored in NVM.
Does not initialize the wired network data stored in NVM.
Automatic fax reception is turned off. You can receive a fax by picking
up the handset of the external telephone, pressing the remote receive
code, and then pressing
Automatically receives faxes.
When the printer receives an incoming fax, the external telephone
rings for the time specified in Auto Ans. TEL/FAX, and then the
printer automatically receives a fax. If an incoming call is not a fax,
the printer beeps from the internal speaker indicating that the call is a
telephone call.
The printer can share a telephone line with an answering machine. In
this mode, the printer will monitor the fax signal and pick up the line if
there are fax tones. If the phone communication is using serial
transmission in your region, this mode is not supported.
Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a
separate number for faxing with a distinctive ring pattern, configure
the fax setup to monitor for that specific ring pattern.
Using the Operator Panel Menus and Keypad
(Start) button.
344