Extreme Flight 125" EXTRA 300 Assembly Manual page 6

7. Use a sharp hobby blade to remove the covering at the location of each servo and seal
the edges with a hot trim iron. Take a few minutes and saturate all joints of the servo
mounting trays with CA.
8. Use the manufacturer supplied hardware to mount the servos in their proper location
with the servo shaft toward the trailing edge of the wing. You will need to use 1- 36", 1-
24", and 1-12" extension to get the servo leads out of the wing. We recommend the use of a
1.5 inch aluminum servo arm. Thread 2 ball links onto the titanium pushrod and install
the pushrod as shown in the picture using the supplied hardware. It will be necessary to
place a washer on each side of the ball link between the brass ball and the fiberglass control
horn to prevent binding.