Radiator (Diesel Engines); Tyres; Wheel Mounting Procedure - Jacobsen Greens King V Plus Service Manual

4 MAINTENANCE
GB
4.16 RADIATOR
WARNING
To prevent serious bodily injury from hot
coolant or steam blow-out, never attempt
to remove the radiator cap while the
engine is running. Stop the engine and
wait until it is cool. Even then, use
extreme care when removing the cap.
CAUTION
Do not pour cold water into a hot
radiator. Do not operate engine without a
proper coolant mixture. Install cap and
tighten securely.
Check coolant level daily. Radiator should be full
and recovery bottle should be up to the cold mark.

4.17 TYRES

1. Keep tires properly inflated to prolong
tyre life. Check inflation pressure while
the tyres are cool. Inspect tread wear.
5. Check the pressure with an accurate, low
pressure tire gauge.
6. Keep tires inflated to:
Front - 0.69 - 0.83 bar
Rear - 0.55 - 0.69 bar

4.18 WHEEL MOUNTING PROCEDURE

1. Remove dirt, grease and oil from stud
thread. Do not lubricate threads.
2. Position wheel on hub and inspect to
insure full contact between mounting
surface of wheel and hub or brake drum.
3. Finger tighten all hardware then torque
hardware in criss-cross order; always
tighten nuts in the top position.
4. Check and retorque daily until torque is
maintained, 115-128 Nm.
JACOBSEN GREENS KING V PLUS
MAINTENANCE AND PARTS MANUAL
Drain and refill annually. Remove the radiator cap,
open the engine block drain and the radiator drain.
Empty and clean the recovery bottle.
Mix clean water with ethylene glycol based anti-
freeze for the coldest ambient temperature. Read
and follow the instructions on the anti-freeze
container and engine manual.
Keep radiator air passages clean. Use compressed
air (30 psi maximum) to clean the fins.
Check and tighten the fan belt. Replace clamps
and hoses every two years.
If you have to add coolant more than once a
month, or add more than one quart at a time, have
a authorized Textron Turf Care and Specialty
Products Dealer check the cooling system.
CAUTION
Unless you have the proper training,
tools and experience, DO NOT attempt to
mount a tyre on a rim. Improper
mounting can produce an explosion
which may result in serious injury.
WARNING
Make sure the tractor is parked on a solid
and level surface. Never work on a tractor
that is supported only by the jack.
Always use jack stands.
If only the front or rear of the tractor is
raised, place chocks in front of and
behind the wheels that are not raised.
GB-19