Hydraulic Oil Filters; Electrical System; Muffler And Exhaust; Care And Cleaning - Jacobsen Greens King V Plus Service Manual

4 MAINTENANCE
GB

4.12 HYDRAULIC OIL FILTERS

The hydraulic system is protected by one 10
micron filter.
To replace hydraulic oil filter:
1. Remove the old filter.

4.13 ELECTRICAL SYSTEM

CAUTION
Always turn the ignition switch off and
remove the negative battery cable (black)
before inspecting or working on the
electrical system.
General precautions that can be taken to reduce
electrical problems are listed below.
1. Make certain all terminals and
connections are clean and properly
secured.
4.14

MUFFLER AND EXHAUST

WARNING
Exhaust fumes contain carbon monoxide
that is toxic and can be fatal when
inhaled.
NEVER operate an engine without proper
ventilation.

4.15 CARE AND CLEANING

Wash the tractor and implements after each use.
Keep the equipment clean.
Note: Do not wash any portion of the equipment
while it is hot. Do not use high pressure spray or
steam. Use cold water and automotive cleaners.
1. Use compressed air to clean engine and
radiator fins. A special blow gun is
available through Textron Turf Care and
Specialty Products Dealer.
2. Do not spray water directly at the
instrument panel, ignition switch,
controller or any other electrical
components, or at bearing housings and
seals.
3. Clean all plastic or rubber trim with a mild
soap solution or use commercially
available vinyl/rubber cleaners.
GB-18
JACOBSEN GREENS KING V PLUS
MAINTENANCE AND PARTS MANUAL
2. Fill new filter with oil then install new
filter. Hand tighten only.
3. Operate engine at idle speed with
hydraulic system in neutral for five
minutes.
4. Check hydraulic oil level in reservoir and
fill to full mark on dipstick.
2. Check the operator backup system, and
circuit breakers regularly.
If the operator backup does not function
properly and the problem cannot be
corrected, contact an authorized Textron
Turf Care and Specialty Products Dealer.
3. Keep the wire harness and all individual
wires away from moving parts to prevent
damage.
4. Make sure the seat switch harness is
connected to the main wire harness.
5. Check the battery and battery charging
circuit.
6. Do not wash or pressure spray around
electrical connections and components.
To protect from carbon monoxide poisoning,
inspect the complete exhaust system regularly and
always replace a defective muffler.
If you notice a change in the color or sound of the
exhaust, stop the engine immediately. Identify the
problem and have the system repaired.
Torque all exhaust manifold hardware evenly.
Tighten or replace exhaust clamps.
Repair damaged metal surfaces and use Textron
Turf Care and Specialty Products touch-up paint.
Wax the equipment for maximum paint protection.
CAUTION
Clean grass and debris from cutting
units, drives, mufflers, and engine to
prevent fires.
WARNING
NEVER use your hands to clean cutting
units. Use a brush to remove grass
clippings from blades. Blades are
extremely sharp and can cause serious
injuries.