3. Four ascending beeps will be emitted, signaling that the reader has been successfully con-
Serial Port Profile (Master)
Read the bar code below to configure the reader in Serial Port Profile (Master) mode.
1. Create a label to link the reader to the PC Bluetooth connection. The label must be Code
Initial Bluetooth® Connection Guide
nected to the Bluetooth-enabled PC. Now you can read bar code labels, and the data will
appear in the MicroRidge Serial Test Program window.
128 symbology and contain the PC Bluetooth address with the following formatting:
The address is usually shown in the Hardware tab of the Bluetooth Devices window. The
label should look similar to this example:
Linking Label Demo in Serial Port Profile (Master)
Serial Port Profile (Master)
$+QS<12hex characters>$-
$+QS70F3958463C1$-
Serial Port Profile (Master)
21