Datalogic PowerScan BT8300 Family Manual page 49

5. After a few seconds, a window will appear showing all Bluetooth devices within radio
6. The next window will display a PIN Code to be used for the connection. A beep will be
Initial Bluetooth® Connection Guide
range. Select the reader you want to connect with.
Each reader found will list the default Bluetooth name of PowerScan BT8300 and
its serial number (look on the body of your PowerScan BT8300 for the label con-
taining the serial number). To set up a unique user-friendly name for each reader,
see the PRG for instructions.
sounded, which indicates the reader is waiting for an alpha-numeric entry.
There are two ways to enter the PIN Code using the reader:
a. Keypad (for PowerScan BT8300 16-key only): type the PIN Code on the reader's
keypad, ending with the Enter key.
b. Scanning: Using the reader, scan the bar codes from the
this guide, corresponding with the required PIN Code digits, then scan the Exit
and Save configuration label.
HID Profile
Numeric Keypad
section of
45