Program Timer Screen - Panasonic CZ-256ESMC2 Operation Manual

3-7. Program Timer Screen

When you use the menu to select [6. Auxiliary settings : 3. Program timer] while logged in as an
administrator, or use the "CHECK" button for timer operation in the remote control window, a screen such
as shown below appears. (As non-administrator users can only confirm settings and not configure them,
the "Cancel" and "Send" buttons only appear when logged in as an administrator.)
Tree section "Cancel"/"Send" buttons
When the daily timer number is selected in the tree section, the current setting status is displayed.
Click the desired setting item, and you can select the setting from the drop-down list as shown below.
Drop-down lists are also displayed for the weekly timer in the same way as the daily timer number.
10
Screen Display and Operation
You can only configure daily timer settings one number (D1, D2, etc.) at a time. If you attempt to switch
to D2 settings in the middle of configuring D1 settings, for example, the message "Send for each daily
timer." appears.
In such a case, apply or cancel the current settings by clicking the "Send" or "Cancel" button, respectively,
before configuring the next daily timer number.
For details on the settings, refer to the operation manual for the Intelligent Controller.
The "Check RC prohib." button appears in the above screen when logged in as an administrator or
special user. When you click on this button, a screen such as shown below appears.
Screen Display and Operation
11