Making Pulse Meter Settings; Main Sub - Panasonic CZ-256ESMC2 Operation Manual

6 Using the System

6.3.5 Making pulse meter settings

If you have connected pulse meters, use this screen to set the target distribution groups and the
amount of electricity or gas per pulse.
Procedure
Select 5. Initial settings in the main menu, and 4. Pulse meter setting in the sub menu.
1.Status/Control
2.Total data/Cut-off 1.Date/Distrib.
3.Distrib. ratio/Usage 2.CNTR/Unit/Ten. No.
4.Maintenance/Test Run 3.Ten. name/Distrib. Gr.
5.Initial settings 4.Pulse meter setting
6.Auxiliary settings 5.Clear accum. data
2
1
1 Select the pulse meter connection destination.
2 You can change the type of pulse meter (power meter or gas meter). The above indicates the
factory default state. When you touch the Meter type area, the Meter type window appears so
that you can select the type of pulse meter to use.
3 Touch a distribution group number. A numeric keypad appears for the distribution group. Use
the keyboard to enter the distribution group number.
* The distribution group number range is from 1 to 8.
* The distribution group buttons are disabled when you have chosen not to perform distribution rate
5 1
5 1
calculations (see ).
Main Sub
4 Touch the pulse unit amount column and enter the amount of electricity (kWh) or gas (m
pulse.
5 If the product type is HOT Multi, select the unit for fuel metering.
28
5 4
5 4
Main Sub
3
5 4 6 7
3
) per
6 Using the System
6 Select this check box for ice heat accumulation night power meters. (Enabled during loaded
distribution setting only.)
* This cannot be set for electricity meters con gured for use with HOT Multi or simple distribution.
7 For the night power meter set in 6, select which outdoor system to meter ice heat accumulation
by selecting the address.
29