Setting Zone Numbers And Management Targets - Panasonic CZ-256ESMC2 Operation Manual

6 Using the System

6.8.2 Setting zone numbers and management targets

Use this screen to set the zone number and management category for individual indoor units. Be
sure to assign a central address to each unit.
Procedure
Select 6.Auxiliary settings in the main menu and 2.ZoneNo./Mng.target in the sub menu.
1.Zone name
2.ZoneNo./Mng.target
3.Program timer
4.Ten.Ho/TimerSp.Day
5.Prohibit R/C
1.Status/Control 6.Distribution time zone
2.Total data/Cut-off 7.Special distrib. day
3.Distrib. ratio/Usage 8.I/D unit settings
4.Maintenance/Test Run
9.Other settings
5.Initial settings
10.WEB settings
6.Auxiliary settings 11.User settings
54
6 2
6 2
Main Sub
2
1
6 Using the System
1 A window like the one shown at right appears when you touch the zone
number column.
Enter digits specify to the zone number.
* Zone No. can be registered in the range 1 to 128.
2 A window like the one shown at right appears when you touch the
management column.
Select one from among Target, Individual operation, or Not Target.
• Individual operation:
Display, total, distribution, and individual operation are possible with
Individual units, but all-unit operations (all tenant units, all zone units,
all connected units, external all stop input, external all start input, etc.)
are not possible.
However, external all-unit alarm output and external all-unit operation
output are possible.
• Not Target:
No operations are possible for Not Target units, including information
5 5 2 6 6
2
display (except for and
Main Sub Main Sub
calculation, and distribution.
55
6 2
6 2
Main Sub
2
2
), totals