Displaying Total Data By Tenant; Main; Displaying Total Data By Outdoor Unit - Panasonic CZ-256ESMC2 Operation Manual

6 Using the System

6.5.2 Displaying total data by tenant

Use this screen to check total data such as the operating time and the number of operations for
each tenant.
Procedure
Select 2.Total data/Cut-off in the main menu and 2.Each tenant in the sub menu.
1 Selects the distribution group to display.
2 Selects either the current or the past (maximum 24 months) cut-off data.
3 Selects the time zone to display.
* This button will be invalid when setting the mode at "No Distrib.". (see
1.Status/Control
2.Total data/Cut-off 1.Each I/D unit
3.Distrib. ratio/Usage 2.Each tenant
4.Maintenance/Test Run 3.Each O/D unit
5.Initial settings 4.Pulse meter
6.Auxiliary settings 5.Cut-off/Data backup
1
4 If you want to display operating time by fan speed, touch Operating time . The display changes
as shown below.
40
2 2
2 2

Main

Sub
5 1
5 1
Main Sub )
1.All hours
2.Regular hours
3
3.Out of hours
4.Special Day
4
2
6 Using the System

6.5.3 Displaying total data by outdoor unit

Use this screen to check total data such as the operating time and the number of operations for
each outdoor unit.
Procedure
Select 2.Total data/Cut-off in the main menu and 3.Each O/D unit in the sub menu.
1 Selects the connection destination link system to display.
2 Selects either the current or the past (maximum 24 months) cut-off data.
1.Status/Control
2.Total data/Cut-off 1.Each I/D unit
3.Distrib. ratio/Usage 2.Each tenant
4.Maintenance/Test Run 3.Each O/D unit
5.Initial settings 4.Pulse meter
6.Auxiliary settings 5.Cut-off/Data backup
Intelligent Ctrl-1
1
Intelligent Ctrl-2
Adapter 1-1
Adapter 1-2
:
Adapter 7-2
• You should make frequent checks of the running time after oil exchanges. When the time approaches
for an oil exchange, contact your dealer or service provider to request an early oil exchange. The
engines of GHP type outdoor unit can be damaged by operation without exchanging the oil.
• For double multiple models comprising two or more outdoor units with the same address, data with a
typical unit are displayed.
• Depending on the model of the outdoor unit, some items may not be displayed.
• Monthly values are displayed for "Operating time" and "Operating count". (The values reset to "0" after
cut-off processing.)
• Cumulative values from the starting point are displayed for "Running time after oil exchange (Hour)" and
"Power output (kWh)". (The values do not reset to "0" even after cut-off processing.)
41
2 3
2 3
Main Sub
2