Camera Video And Power Cable Installation - Iteris RZ4 Advanced Installation Manual

7. Programming
a. Labels: Camera, Configuration, Zones
b. Check using MOD (Mode) menu item
Channel Assignment and Zone Type
c. Set MOD (Mode) 'Inact/Ch to "NoCall"
d. Set Options if needed
e. Set Clock (Clk) Time and Date information
f. Make sure the test switches are all in the middle position (normal)
8. Archive snapshots and configurations. using VRAS
9. Observe operation during critical times
Morning transition
Noon time
Evening transition
Night time
10. Document count zones (if used)
11. Turn OFF menu / Turn Off Monitor
This is by no means intended to be a detailed and all inclusive list.

4.2 Camera Video and Power Cable Installation

This procedure describes how to install the coaxial and power cables between the camera mounting
location and the traffic control cabinet. If you are installing multiple cameras, perform the procedure for
each camera.
The procedure is divided into the following parts:
1. Running the cables
2. Preparing the coaxial cable connectors
3. Preparing the power cable connectors
4. Preparing the coaxial cable at the cabinet
Running the Cables
1. Run one continuous pull (without splices) of coaxial cable and power cable between the camera
mounting location and the traffic control cabinet. The cables need to meet the following specifications:
•
Belden 8281 coaxial cable
•
Three‐conductor, 16 AWG power cable
See the "Technical Information" section for the specific cable specifications.
3