Camera Installation Supplies; Processor Installation Supplies; System Installation; Vantage Installation Turn-On Checklist - Iteris RZ4 Advanced Installation Manual

3.2 Camera Installation Supplies

1. ½" or ¾" stainless steel banding material – user supplied
2. Amphenol 31‐321‐1012 BNC connector (one per camera) used in the controller cabinet for the
surge protection device – included with camera
3. Belden 8281 coaxial cable (one per camera) – user supplied
4. Three‐conductor, 16 AWG power cable (one per camera) – user supplied

3.3 Processor Installation Supplies

A surge suppressor device should be used on the video input line. Iteris provides a surge suppressor
from EDCO, part number CX06‐M (in‐line unit) with every Edge processor.
4

System Installation

4.1 Vantage Installation Turn-On Checklist

This checklist can be used as a guideline for some of the necessary considerations that must be
remembered whenever installing and turning on an intersection using the Vantage video detection
system.
1. Correct Coax and Power Cable
a. Video coaxial cable = Belden 8281
b. Power cable = 3 conductor, 16 gauge, stranded wire
2. Surge Protection ‐ Installed / properly grounded
3. Camera Installation
a. Use 3 stainless steel bands to mount the pedestal bracket on the luminaire arm.
b. Power connection on camera backplate – Correct pin assignment
c. Video connection on camera backplate
d. Sun shield adjusted ‐ pulled out (Extended)
e. Camera tilted slightly downward
4. Camera FOV (Field Of View)
a. No Horizon in FOV
b. Minimum 4 lane width
c. Camera FOV sees just past advanced detection zones if under 300' from stop bar
d. Car bumpers parallel to bottom of screen
e. Adequate area remaining for far detection
5. Processor Installation
a. Jumpers / switches properly set
6. Zones
a. Size of average vehicle (sedan)
b. Longitudinal pavement markings out of zone area
c. Curb and gutter out of zone area
d. Symbol markings contained in zone
e. Low Contrast (LC) veto zones properly drawn
2