Figure 5.10
Too Much Camera Visor in the FOV Maximum Acceptable Amount of
Rotate the Camera Body
Ideally, for most intersection applications, vehicles should flow from the top of the screen to the bottom
of the screen. By loosening the two hose clamp set screws, the camera body can rotate to better square
up the FOV image.
The car bumpers should also end up being parallel with the bottom of the screen.
Figure 5.12
The Camera Body Could Be Rotated
To Help Square Up The Stop Bar Area
Figure 5.11
Visor in the FOV
Figure 5.13
The above picture shows an acceptable
FOV and stop bar area alignment.
16
Need help?
Do you have a question about the RZ4 Advanced and is the answer not in the manual?