Table 3-3 Security Screen Parameters - Silicon Graphics Zx10 User Manual

007-4330-002
Note: When you enter a password, it is saved immediately. All other changes may still
be discarded (see "Exit Screen" on page 49 in this chapter).
Warning:
If you forget the supervisor password, it cannot be disabled without
clearing CMOS memory. See "Using CMOS Reset" in this chapter for more
information.
Table 3-3 Security Screen Parameters
Parameter
Supervisor Password Is
User Password Is
Set Supervisor Password
Set User Password
Password on Boot
Diskette Access
Description
Displays the state of the supervisor password.
Displays the state of the user password.
Sets the supervisor password. Press
dialog. To disable a set password, set the password to nothing
(press enter without typing a password).
Sets the user password. Press enter to display the entry dialog. To
disable a set password, set the password to nothing (press enter
without typing a password).
Controls whether a password is required to boot the system. You
can use either the supervisor or user password. By default, this
parameter is Disabled.
Controls access to the floppy disk drive if passwords are set. By
default, this parameter is Supervisor.
Security Screen
nter to display the entry
E
47