F lyw hee l/D rive Belt Rep lac eme nt
( 1 . 2E , 2.2 E , 3. 2E, 4.2E) Conti nu e d
Fi g u r e 6
A
TENSION BOLT
FLYWHEEL
6) Remove both nuts (A), which hold the flywheel to frame.
7) Remove the nuts (B) holding the tensioning bolts into position on both sides of the flywheel and remove the
belt-tensioning bolts.
8) Remove drive belt from crank pulley.
9) Place new flywheel into position and attach drive belt onto crank pulley.
10) Slide belt-tensioning bolts onto the flywheel axle.
11) Loosely thread bolts (A) onto the flywheel axle.
12) Tighten the nuts (B) to adjust the tension of the drive belt.
TENSION BOLT
B
Make sure that both bolts are tightened equally so that flywheel sits straight in
frame and both fly wheel and crank pulley are properly aligned.
Fi gure 6
A
B
TENSION BOLT
FLYWHEEL
B
TENSION BOLT
A
55