R P M S ens or Continuity Check
F i g u r e 1
OHMS
1.2E
1) Turn your multi-meter setting to Ohms.
2) Place the positive lead of your multi-meter on the tip of the sensor wire jack and the negative lead on the
outside of the sensor wire jack.
3) Turn crank to produced an rpm in order to get continuity through the sensor wire.
All Models Except 1.2E
1) Turn your multi-meter setting to Ohms.
2) Remove console and disconnect console cable.
3) Put one lead into the purple pin (P1) and the other on the yellow pin (P7). (Please refer to the Console Cable
Voltage Check on page 16)
Turn crank to produced an rpm in order to get continuity through the sensor wire.
1