1. Manuals
  2. Brands
  3. Ekofires Manuals
  4. Indoor Fireplace
  5. 1030
  6. Installation & user's instructions

Ekofires 1030 Installation & User's Instructions

Lcd inset electric fire
Hide thumbs
1
2
3
4
5
6
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION & USER INSTRUCTIONS
Christchurch, Dorset BH23 2BT
Tel: 01202 588 638
Fax: 01202 499 639
www.ekofires.co.uk
e-mail: sales@ekofires.co.uk
PLEASE NOTE: EKO 1030 ELECTRIC FIRES MAY BE SUPPLIED WITH DIFFERENT FRET & FRAME
Please note : Except where otherwise stated, all rights,
including copyright in the text, images and layout of this
booklet is owned by Focal Point Fires plc. You are not per-
mitted to copy or adapt any of the content without the
prior written permission of Focal Point Fires plc.
LCD ELECTRIC FIRE
MODELS COVERED BY THESE INSTRUCTIONS
1030 LCD INSET ELECTRIC FIRE
FRET AND FRAME OPTIONS AVAILABLE
MODEL SHOWN : EKO 1030 LCD INSET ELECTRIC FIRE
THAN SHOWN
All instructions must be handed to the user
Revision B - 01/14
1
GB IE
for safekeeping.
2014 Focal Point Fires plc.
'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1030 and is the answer not in the manual?

Questions and answers

Related Manuals for Ekofires 1030

Summary of Contents for Ekofires 1030

  • Page 1 MODEL SHOWN : EKO 1030 LCD INSET ELECTRIC FIRE PLEASE NOTE: EKO 1030 ELECTRIC FIRES MAY BE SUPPLIED WITH DIFFERENT FRET & FRAME THAN SHOWN All instructions must be handed to the user Please note : Except where otherwise stated, all rights, including copyright in the text, images and layout of this for safekeeping.

  • Page 2: Appliance Data

    I N S TA L L AT I O N & U S E R I N S T R U C T I O N S GB IE Section Contents Page No. Section Contents Page No. Preliminary Notes Fitting The Decorative Frame And Front 3 Appliance Data Operating The Appliance Installation Requirements...

  • Page 3: Unpacking The Appliance

    3.0 INSTALLATION REQUIREMENTS - GB IE CONTINUED This appliance should be positioned on a firm level surface and in a clean ‘dust free’ environment. If the fire is to be sited in a fire surround then the suitability of the surround for use with electrical heaters should be established with the fire surround manufacturer. If fitted into an open draught fireplace, it is advisable to blank off the chimney to reduce the risk of draught through the fire, which may cause the safety cut out system in the fan heater to operate.

  • Page 4: Operating The Appliance

    8.0 OPERATING THE APPLIANCE GB IE Read All Instructions Before Use Check that the heater outlet grille, mounted at the top of the appliance, is not covered or obstructed in anyway, and ensure the power to the fire is switched on.The power to the LCD display panel and the heater functions are controlled using three switches mounted underneath the hood on the left hand side.

  • Page 5: Cleaning And Maintenance

    9.0 SAFETY CUT -OUT SYSTEM GB IE This appliance has a safety cut-out system fitted which will activate if the air inlets or heater outlets are obstructed. For safety reasons the fire WILL NOT switch on again automatically. NOTE: The LCD display panel will remain operational if the cut-out is activated, only the fan heater elements are prevented from operating.
  • Page 6 Please note that this does not affect your statutory rights. Eko Fires ltd, 3G Service Department, Reid Street, Christchurch, Dorset, BH23 2BT. Alternatively email: service@ekofires.co.uk or fax. 01202 499326. Details required: 1. Name, full address including post code and contact telephone number.

Table of Contents