Cooktop Servicing; Removing And Replacing Cooktop - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Removing And Replacing Cooktop (Sealed Burner Models)
The photographs and instructions in this section will guide you in the disassembly and replacement The photographs and instructions in this section will guide you in the disassembly and replacement
of the cooktop, surface burner orifi ce assembly, manifold panel, manifold and surface burner control of the cooktop, surface burner orifi ce assembly, manifold panel, manifold and surface burner control
valves on gas ranges with sealed surface burners. valves on gas ranges with sealed surface burners.
To remove the main top fi rst remove the grates, To remove the main top fi rst remove the grates,
burner caps and burners. Using a ¼" socket burner caps and burners. Using a ¼" socket
wrench or nut driver remove the mounting wrench or nut driver remove the mounting
screws at each burner orifi ce assembly. screws at each burner orifi ce assembly.
(Photo 1) (Photo 1)
Insert a putty knife or similar tool between the Insert a putty knife or similar tool between the
main top and manifold panel near the outside main top and manifold panel near the outside
of the front corner. Push the putty knife toward of the front corner. Push the putty knife toward
the rear to release the maintop mounting clip. the rear to release the maintop mounting clip.
Repeat for both sides. (Photo 2) Repeat for both sides. (Photo 2)
When the mounting clips are released the front When the mounting clips are released the front
edge of the cooktop can be lifted. Make sure edge of the cooktop can be lifted. Make sure
that the orifi ce assembly does not bind in the that the orifi ce assembly does not bind in the
cooktop when raising the top to remove it from cooktop when raising the top to remove it from
the range. (Photo 3) the range. (Photo 3)
MAINTOP MOUNTING MAINTOP MOUNTING
CLIP CLIP
Lift the front of the cooktop and pull forward to Lift the front of the cooktop and pull forward to
disengage the back edge from the rear hinge disengage the back edge from the rear hinge
bracket. The cooktop can now be replaced by bracket. The cooktop can now be replaced by
reversing the previous steps. (Photo 4) reversing the previous steps. (Photo 4)
Rear Hinge Bracket Rear Hinge Bracket

COOKTOP SERVICING

Page 21
Orifi ce Assembly
Mounting Screws
Photo 1
Photo 2
Photo 3
Photo 4
P/N 316439221