Range Installation Instructions; Delivery Installation Bulletin - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Gas Range Installation – Prevent Damage to Range Gas Tubing and
Pressure Regulator

DELIVERY INSTALLATION BULLETIN

The procedure described below will prevent the deformation
of the gas regulator mounting bracket and gas tubing leading
to the gas regulator. Refer to the instructions provided with
this range for complete
installation instructions.
NOTE: Be sure to carefully follow the service procedure
as described below. Use NO MORE THAN 15 ft./lbs. of
torque when tightening the gas fi ttings and/or gas fl exible
appliance conduit to the gas regulator.
The gas regulator and associated gas lines should appear as
in Fig. 1. You may then proceed with the gas installation by
following the recommended procedures found in the Instal-
lation Instructions for the range.
It is unacceptable to continue with the gas service installa-
tion if the deformation to the gas lines is as shown in Fig. 2.
As an additional precaution perform the following instruc-
tions to avoid deformation of the gas lines and gas regulator
mounting bracket:
1. Stabilize the left side of the gas regulator with an adjust-
able wrench as shown (See Fig. 3). PLEASE NOTE: Be
careful not to damage the Gas Shut-Off Valve.
2. Tighten the gas supply fi tting and/or gas fl exible appliance
conduit to the right side of the gas regulator using 15ft./lbs.
of torque (See Fig. 4).
3. Check to make sure the gas lines and the gas regulator
mounting bracket are not deformed before supplying gas to
the range.
NOTE: Also, check to make sure that the Gas Shut-Off
Valve is still in
the ON position (See Fig. 5).
Fig. 5
Page 10
Fig. 1
Fig. 2
Fig. 3
Fig. 4
P/N 316439221