Table of Contents
Advertisement
Changing Cooktop
and
Be sure the oven is unplugged and all parts are COOL before
Oven Lights
(some models)
replacing the oven light.Wear a leather-faced glove for protection against possible
broken glass.
Fluorescent
LJgh|
0
Glass
Frame
To Change
the Cooktop
Light
(some
models)
Use the rocker switch located on the top left side of the control panel to turn the
cooktop light on or off.
1_ Turn power off at the main source or unplug the range_
2_ Remove control buttons_
3.
Remove screws from backguard frame trim, two from each side, and lift off.
Remove the glass panel.
4.
Removebulb by sliding your fingers over the bulb at eachend and rotating the
top of the bulb 1/4 turn away from you. Replacethe bulb with one of the same
length and wattage.
5.
A defective starter can be removed by turning it counter-clockwise 1/4 turn.
6.
Replace the glass panel and frame trim on backguard.
7.
Replace screws and control buttons.
To Change
the
Oven
Light
Use the rocker switch located on the top left side of the control panel to turn the
oven light on or off.
1o Turn electrical power off at the main source or unplug the oven.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
44 Replace glass shield in socket and snap wire holder into place.
54 Turn power back on again at the main source (or plug the oven back in).
64 The clock wi!l then need to be reset, To reset, see Setting
the Clock and
Minute Timer
in this Owner's Guide.
Adjusting
Oven
Temperature
(Easyand continuous cleaning models
only, Self-cleaning model refer to the
electronic timer guide)
Figure t : Back of Control Knob
_' Note position of pointer
prior to adjustment
The temperature in the oven hasbeen set at the factory, When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven is too hot
or too cool, the temperature in the oven can be adjusted. Before adjusting, test a
recipe by usinga higher or lower temperaturethan the recommended temperature.
The baking resultsshould help you to decide how much of an adjustment is needed.
To Adjust Oven Temperature:
1. Check to be sure the Temperature Control knob is in the OFFposition,
2.
Pull Temperature control knob straight off the shaft.
3.
Loosen. but do not remove, the two screws at the back of the knob (Figure 1).
Note: tf knob does not have 2 screws, it is not adjustable. There isa series of
small indicator grooves, One of these grooves is positioned next to a tiny
pointer. Note the position of the pointer.
4.
To increase the temperature, move the pointer in a clockwise direction. To
decrease the temperature, move the pointer in a counterclockwise direction.
The temperature can be adjusted in increments of 10°F.
5.
When the desired adjustment is reached, tighten both screws.
6.
To replace the knob, line up the flat sides of both the knob and the shaft. Push
the knob into place. DO NOT force the Temperature Control knob onto the
shaft or you may damage the back of the knob.
Note: Once an adjustment ismade, the OFF position will vary from the reference
mark on the backguard depending on the amount of adjustment.
17
Advertisement
Table of Contents
