Servicing Bake Burner And Ignitor - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Servicing Bake Burner and Ignitor

Remove the two screws securing the front of the
bake burner baffl e to the range chassis. Lift the
front edge of the baffl e high enough to clear the
chassis and pull forward to disengage the rear
tabs on the baffl e from the slots in the oven liner.
Remove the baffl e from the oven cavity.
With the baffl e removed the bake burner and
ignitor can be accessed for service.
Remove the warmer drawer per the instructions
on page 7. With the warmer drawer removed the
wire harness plug connector for the ignitor can be
disconnected.
When replacing the bake burner
ignitor it is necessary to remove
the burner assembly.
After the ignitor harness plug is disconnected re-
move the two burner mounting screws and lift the
burner assembly out of the range. The ignitor can
now be separated from the bake burner assem-
bly by removing the two ignitor mounting screws.
When reinstalling the burner assembly make
sure to properly position the base of the burner
tube over the orifi ce spud on the oven gas safety
valve.
SERVICING OVEN BURNERS AND COMPONENTS
Baffl e Mounting Screws
Warmer Element
Harness plug
Power Cord
Harness Plug
Burner Mounting
Screws
Page 25
Ignitor Harness
Connector Plug
P/N 316439221