Model & Serial Number Location; Care, Cleaning & Maintenance; Before You Call For Service - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Hide thumbs Also See for 30” GAS FREESTANDING RANGES:
Table of Contents

Advertisement

30" GAS RANGE INSTALLATION INSTRUCTIONS
11. Air Shutter-Broil Burner
The approximate flame length of the broil burner is 1 inch
(distinct inner, blue flame).
To determine if the broil burner flame is proper, set the oven
to broil.
If the flame is yellow in color, increase air shutter opening
size. (See "2" in illustration above.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in illustration above),
reposition air shutter, and tighten lock screw.
12. Make Sure Range is Level.
Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by either adjusting the leveling legs or by placing shims
under the corners of the range as needed.
13. After installation is complete, make sure all
controls are left in the OFF position.
Model and Serial Number Location
For sealed burner ovens, the identification plate is located on
the right-hand surface of the oven front frame at the storage
or warmer drawer; or the lower panel area.
When ordering parts for or making inquires about your range,
always be sure to include the model and serial numbers and
a lot number or letter from the identification plate on your
range.
Your identification plate also tells you the rating of the
burners, the type of fuel and the pressure the range was
adjusted for when it left the factory.
(For Models with Sealed Top burners)
Page 18
Care, Cleaning and Maintenance
Refer to the Use & Care Guide for cleaning instructions.
If removing the range is necessary for cleaning or
maintenance, shut off gas supply. Disconnect the gas and
electrical supply. If the gas or electrical supply is inaccessible,
lift the unit slightly at the front and pull out away from the wall.
Pull only as far as necessary to disconnect the gas and
electrical supply. Finish removing the unit for servicing and
cleaning. Reinstall in reverse order making sure to level the
range and check gas connections for leaks. See page 3,
step 1 for proper anchoring instructions.

Before You Call for Service

Read the "Before You Call" and operating instruction sections
in your Use & Care Guide. It may save you time and expense.
The list includes common occurrences that are not the result
of defective workmanship or materials in this appliance.
Refer to the warranty in your Use & Care Guide for our toll-
free service number and address. Please call or write if you
have inquiries about your range product and/or need to order
parts.
P/N 316439221

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents