Bodyside Mounting; Leg Levelers - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Changing the body side panel requires the re-
moval of screws along the top and rear fl anges
and removing the two screws securing the front
leg leveler to the chassis.
When replacing the body side panels depending
on the model there may be two hidden fasteners
that must be addressed. The fi rst is a screw on
the inside fl ange of the body side just behind the
face of the chassis as shown in the photo to the
right.
The second hidden fastener is located further
down this same fl ange. The photo on the right
shows a close up of the plastic retainer which
is screwed to the side of the oven chassis. A
square opening in the side panel hooks on the
underside of the fastener.
Lower the body side panel to disengage the slot
from the retainer.
NOTE: This second fastener will not appear on all
models
A newly designed, front mounted leg leveler has been added to provide for greater stability and easier
access for adjusment. The new leveler is attached to the range two screws in the front that pass
through the lower edge of the body side and into the oven chassis, and one screw from beneath that
attaches to the body side panel.
NOTE: The front and rear leg levelers must be removed from
the original bodyside panel and mounted on the new one before
it is installed on the range.
REAR

BODYSIDE MOUNTING

LEG LEVELERS

FRONT
Page 36
←
Front of range
Left Bodyside
Hidden Screw
REMOVE SCREWS
Retainer
The leg leveler
assembly will
remain attached
to the bodyside
panel
P/N 316439221